|
SPE Downloads Page |
| |
|
| |
|
| |
From time to time we offer
downloads for customers |
| |
and technicians from this
page... |
| |
|
| |
Credit Application: |
| |
Click here to download our Customer Credit Application... |
| |
|
| |
New Maryland 6% Sales Tax: |
| |
Click here to download the new MD 6% Tax Chart - For those not
having a GSite |
| |
|
| |
If you are programming this into a Gilbarco
GSite system you may try these steps to get your tax table
correct. At this time this procedure hasn't been tested, but
it may get you started in the correct direction.
To access the screen below, enter into Manager
Mode on your GSite. Then enter into menu 5.Tax Programming,
then 2. Tax Table Programming, then choose 1. Tax Table 1.
Tax table 1 is most likely a 5% tax table. You are going to
have to replace the 5% tax table with this 6% tax table.
After you make the changes don't forget to update your programming
changes in Supervisor Mode (Yellow Key) under Product Data
Control.
Sample GSITE Screen
|
| |
| |
|
|
|
Tax Rate: |
6.000% |
|
|
Start |
|
End |
Tax |
|
|
|
.00 |
- |
.18 |
.00 |
|
|
|
.19 |
- |
.20 |
.01 |
|
|
|
.21 |
- |
.33 |
.02 |
|
|
|
|
.34 |
- |
.50 |
.03 |
|
|
|
|
.51 |
- |
.66 |
.04 |
|
GSite requirements: |
|
|
.67 |
- |
.83 |
.05 |
|
|
|
|
.84 |
- |
1.00 |
.06 |
|
You must go past 1.00 |
|
|
Cycle Start |
|
|
|
|
1.01 |
- |
1.16 |
.07 |
|
You must complete |
|
|
1.17 |
- |
1.33 |
.08 |
|
a cycle that is |
|
|
1.34 |
- |
1.50 |
.09 |
|
1.00 or more that is |
|
|
1.51 |
- |
1.66 |
.10 |
|
repeatable |
|
|
1.67 |
- |
1.83 |
.11 |
|
|
|
|
1.84 |
- |
2.00 |
.12 |
|
|
|
|
2.01 |
- |
2.16 |
.13 |
|
|
|
|
Cycle End |
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
| |
Make sure you read the
directions for navigation at the bottom of the page on your GSite
screen. |
| |
For example, hitting
"Cash" starts the cycle, or to get to another page you hit "%" |
| |
|
| |
*If these directions do not work and you
cant get out of the screen by hitting subtotal, don't panic, just
remove the black key, or if you have keyless, simply hit "G", "6",
"6" to get out of manager mode. Using this procedure will
get you out of tax programming mode and undo any changes you have
made! |
| |
|
| |
*** DON'T FORGET TO UPDATE YOUR CHANGES
IN SUPERVISOR MODE!!! |
| |
|
